DH. 82A Tiger Moth SPACE
ICM
Eduard | N. 3DL32002 | 1:32
I fatti
- Marca:
- Eduard
- Titolo:
- DH. 82A Tiger Moth SPACE ICM
- Numero:
- 3DL32002
- Scala:
- 1:32
- Digita:
- Set di dettagli
- Codice a barre:
- 8591437557837 (EAN)
- Argomento:
- De Havilland DH 82 Tiger Moth » Elica (Aereo)
Contenuto della confezione
Fotoincisioni (Multi-colored), Decals (3D) (Multi-colored)
Contenuto della scatola »Istruzioni
Scaricare 3729Kb (.pdf)
Mercato
No partner shops available
Recensioni in-box
Revisioni esterne
Annuncio pubblicitario
Commenti
Kenneth
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
21 January, 10:37
Materiale di riferimento
Tutti i libri » (12 in totale) Tutti i walkaround (immagini dei dettagli) » (6 in totale)